Tangit PVC-U adhesive

Pipe adhesive for bonding thermoplastic pressure piping systems made of rigid PVC (PVC-U)

    Long open time of 4 minutes
    Excellent gap bridging behavior
    Highest protection against leakage

Product advantages:

    Long open time of 4 minutes
    Also easy to glue larger dimensions (up to 80 mm is enough a person)
    Simple and clean handling
    Improved safety through excellent gap-bridging behavior (low yield value)
    Highest protection against leakage
    Adhesive bond as constant as the pipe material (except concentrated acids)
    Meets DIN EN 14814 and DIN EN 14680
    Meets EN 1329 for draining water in plastic pipe systems
    Certified by the testing institute "Water Technology Center Karlsruhe" (TZW)
    Excellent for use in food applications (SGS Institut Fresenius, test report no. 727685-01 / 02)

Usage:

    For bonding thermoplastic pressure piping systems made of rigid PVC (potable water, gas) - to EN 1452
    Suitable for non-pressure pipe systems (sewage) - EN 1329
    Installation and repair work (eg. As gutters)
    Ideal for Konstruktionsklebungen with PVC sheet material (eg. As sumps, housing boxes)

Special instructions:

    Avoid open flames and sparks
    Workrooms well attended / Bleed
    Wear suitable protective clothing during work
    Please also see the technical data sheet and the safety data

Processing instructions:

    Pipe end perpendicularly, outside chamfer (15 °) and deburring
    Adhesive surfaces pre-clean and dry. Mark Rohreinstecktiefe on the pipe end
    Tangit cleaner PVC-U / PVC-C / ABS apply on absorbent paper towels and clean the dry joint surfaces thoroughly. Replace towels after each cleaning process
    Tangit Stir before use - both sides with brush in the longitudinal direction (molding thin tube end thicker), apply, assemble pipe and fitting without tilting and twisting within the open time and fix a few seconds
    not claim After joining connection min. 5 min. mechanically
    Lowering glued pipes in the trench at the earliest 10 -12 Std.nach the last bond
    Waiting time for start-up in case of repair and pressure test at relaying to 24 hours per bar 1h.

Consumption:

Enough for about 30 bonds at d = 63 mm (calculated for 500 g)